Professional panel-mounted SPD installation with proper grounding verification. Protect your appliances, electronics, and HVAC before the next surge hits.
Most homeowners do not buy surge protection until after the surge.
That is a real pattern. The phone rings on a Monday morning, two days after the storm, and the call is about a refrigerator that stopped working, a microwave that came on but does not heat, an HVAC system that runs but does not cool, and a garage door opener that is now decorative. None of those failures looked like surge damage to the homeowner. They looked like equipment that died for no reason.
The surge protector that would have prevented most of it costs less than the cheapest item on that list.
This page is about installing the protection before the bill arrives, not after.
Type 2 SPD installed with shortest possible lead lengths, proper torque, and low Voltage Protection Rating (600V or lower). Status indicators included.
Additional Type 2 SPDs for detached garages, workshops, ADUs, and large additions where justified.
Type 3 surge suppressors for home theaters, servers, medical equipment, and high-value electronics.
Full grounding electrode system inspection and correction before SPD installation.
Surge protection does not announce itself. A whole-house surge protective device sits on the wall next to the panel, indicates green, and absorbs voltage transients silently for years.
The benefit shows up in things that did not happen: appliances that last longer, electronics that survive storms, HVAC equipment that runs longer between failures.
The dominant cause is cumulative: utility switching, neighbor HVAC cycling, motor inrush, and minor lightning activity. A whole-house SPD clamps the worst events and extends equipment life significantly.
Quality Type 2 SPD with low VPR and warranty
Clean install with short lead lengths
Verification and remediation if needed
A straightforward whole-house SPD installation in West Menlo Park takes between one and three hours depending on panel access and condition.
Typically every five to seven years in West Menlo Park, CA depending on surge activity. Status lights show when replacement is needed.
No. It protects against induced voltages and switching surges. Direct strikes require a full lightning protection system with proper bonding.
The NEC requires it in many configurations. We confirm local requirements during the site visit.
In almost every case, yes. We assess compatibility during the site visit.
Get professional whole house surge protection installed correctly with verified grounding in West Menlo Park.
Click Here to Call (888) 355-9624